hanging closet bin for unused space above clothing hangers
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
This is a light-weight basket/bin I made to hold some socks. It fits in my closet above the clothes hangers.
- Ocena
- 0 / 5
- Polubienia
- 11
- Pobrania
- 19
- Wydruki
- 0
- Wyświetlenia
- 182
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Bedroom
- Licencja
- Creative Commons — Attribution — NoDerivatives
This is a basket/bin I made to hold some socks. It fits in my closet in the unused space above the clothes hangers.
It can be attached using double sided tape or using screws. Be careful with screws because the back panels in these closets are often made from very thin wooden panels. I used double sided carpet tape cut to size.
The size is 300x200x180mm. About 95 grams.
Printing
I printed this in Jayo PETG on an SV08 using a 0.6mm nozzle. I slowed down the acceleration/speeds a bit to prevent printing issues because an earlier attempt (with much thinner walls) had printing problems because the machine was shaking too much.
I did not need any supports to print this. Print it with the closed flat rectangle side on the printbed, as shown in the picture on the table. It doubles as a brim during printing. Set walls to 5 and/or infill to 100% to get the max rigidity.
This will not print correctly on a bedslinger!