1 / 1
Repair fix for all of Martin's Star Trek Starships Stands — zdjęcie 1

Repair fix for all of Martin's Star Trek Starships Stands

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

I found the peg on top of the stand for the Star Trek ships by Martin would break off - so here is a repair piece!

Ocena
0 / 5
Polubienia
2
Pobrania
13
Wydruki
0
Wyświetlenia
70
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Kategoria
Vehicles
Licencja
Creative Commons — Attribution — Noncommercial — Share Alike

The stands for the starships of Star Trek by Martin have a little peg on top of the mostly rectangular post - I found that due to varying tolerance issues that sometimes the peg was at risk of snapping off during assembly. Assuming the stands are all the same (I haven't printed them all yet!) I've designed a fix/repair for this issue.

Fits firmly over the rectangular post needing no adhesive. Just trim off any remaining peg from the stand with flush cutters, and remove any peg remains from the hole in the model, and fit firmly over the top of the now flat stand arm. It should be an incredibly snug fit so be careful not to break anything further. Then you can seat the model back on the new peg.

I recommend printing in the same colour as you printed the stand, but I'm not your mum so do as you like.

Requires no infill or supports, prints in around 5 minutes. If you need to scale it down just make sure you have enabled printing thinner walls in your slicer.

Tagi