Viofo A129 Pro Duo Front Cam Shell + Upgrade Mount
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Just a fun project to replace my old dash cam body with some modifications that might not be as useful, Haha!
- Ocena
- 0 / 5
- Polubienia
- 1
- Pobrania
- 6
- Wydruki
- 0
- Wyświetlenia
- 110
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Automotive
- Licencja
- Creative Commons — Attribution — Noncommercial
Hello guys, again with another fun project replacing my old Viofo A129 Pro Duo dashcam body that has been sitting in the sun for an extended period, and is starting to become brittle and break apart. Since I didn't find any printable replacement, I have to come up with my own solution + additional mods that might not be as useful. Hope you all find it useful. Cheers!
Bill of materials:
x8 M3 Heatset inserts
x9 M3x6 screws (x8 for assembly, x1 for holding the camera tilting mechanism in place)
Original parts, including its mounting screw, button, camera module, and tilting mechanism
-> Additional BOM with fan installed
x4 M3 Heatset innserts
x1 3010 5v radial fan (or a thicker fan is acceptable)
x4 M3x12/x14 screws (for fan mounting)
Print material and parameters: at least ABS (have not tested its durability with long exposure under the sun yet, but I would recommend at least starting with ABS), with Voron printed parameters will be fine. No support required.
Assembly:
Place the buttons into the slot.
Install the PCB by tilting it on its side, and align the connector -> mounting it with the original mounting screws.
Connect the camera module with its tilting mechanism -> secure the mechanism by screwing the M3x6 into the body.
Attach the speaker and microphone.
Insert the heatset insert onto the mounting part and assemble with the top cover by securing with M3 screws. (Please note that the fan opening is facing toward the camera module)
Assemble the top cover with the body by screwing the x4 M3x6 screws directly into the printed part -> only hand-tightening is recommended to prevent stripping the printed part.
Note: Since my unit suffered from both the GPS module not working and the ribbon cable being short-circuited multiple times. I decided to get rid of the module and connect the power via the main connector on the dash cam directly. Hence, this model doesn't support a GPS module.
FYI regarding the addition of a fan: I've tested the dashcam operation with the fan and found that the wind noise that I'm afraid will interfere with the microphone seems to be acceptable for my unit (suspicious faulty microphone for my unit, though). I would suggest you guys try it out to see if the wind noise is acceptable.