Ultra Compact Tripod Plate for Olympus E-10 and E-20
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Very low profile arca-type tripod plate and strap connector designed to fit the Olympus E-10 and E-20.
- Ocena
- 0 / 5
- Polubienia
- 2
- Pobrania
- 2
- Wydruki
- 0
- Wyświetlenia
- 42
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Photo & Video
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
About the design
Low profile arca-type tripod plate designed to fit Olympus E-10 and E-20. It's designed to match the lozenge shape on the bottom of the camera, just because I thought that looked nice. It has room for a strap connector on the back corner, and pegs that fit into the holes on the camera body to prevent wiggle.
Attaching it
I used these screws: https://www.mcmaster.com/91792A533/
They are standard 1/4" 20 thread with a 1/4" shaft, and a 0.144" deep by 0.492" wide head.
⚠ Disclaimer! Use at your own risk!
I have been using 3d printed tripod plate + strap connector combos for years with no problems, but ultimately the safety of your gear is up to you, and I take no responsibility for any damages caused if your copy of this design breaks or does not work with your gear.
Probably don't carry the camera by this while using heavier accessories such as the TCON-300 teleconverter (although you'd have to remove it to attach the support rail anyway). It might be strong enough but I wouldn't trust it.