1 / 1
5mm to 7mm RC wheel hex adapter for MN82 and others
Zamów wydruk tego modelu
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Allows using 7mm hex wheels on axles with a 5mm shaft - intended for MN82 but usable on other vehicles
- Ocena
- 0 / 5
- Polubienia
- 6
- Pobrania
- 70
- Wydruki
- 0
- Wyświetlenia
- 418
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- RC & Robotics
- Licencja
- Creative Commons — Attribution — Share Alike
SzczegółyPliki (2)Wydruki i komentarze (Wydruki: 0) (Komentarze: 1)Remiksy (0)Kolekcje (10)Powiązane
Craig of RC TNT created some hop-up parts for the MN82 and gave them away on his page. But I switched to the metal axles and his wheel hex adapters don't fit them well, and the axle shaft spins in the adapter. This is a remake (from scratch in freecad, not a remix) that fixes this problem.
Now including: Cut template for MN82 axle. Just slip these onto the axle shafts and either mark a line around the shaft (perhaps with a scribe) or just use the sleeve as your cut guide.
