1 / 3
IKEA LAUTERS Lamp Shade Repair Kit (Fix for broken welds) — zdjęcie 1
1 / 3

IKEA LAUTERS Lamp Shade Repair Kit (Fix for broken welds)

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

A two-part clamp to repair the IKEA LAUTERS lamp shade when the original spot-welds on the center ring fail.

Ocena
0 / 5
Polubienia
2
Pobrania
11
Wydruki
0
Wyświetlenia
108
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Kategoria
Home Decor
Licencja
Creative Commons — Attribution — Noncommercial

The IKEA LAUTERS lamp shade has a common flaw: the thin metal arms are only spot-welded to the center ring. Over time, these welds often snap off, making the shade unusable.

This model is a two-part replacement ring that clamps the broken arms back together. It’s designed to be bolted together, creating a much stronger mechanical joint than the original welds.

Assembly instructions:

  1. Place the broken arms into the slots of the bottom ring.

  2. The slots have a slight clearance—I highly recommend adding a few drops of polymer glue (or any strong adhesive) into the slots before assembly.

  3. Place the top ring over the arms.

  4. Bolt both parts together using 3x M4 screws (6mm or 10mm length) and 3x M4 nuts.

  5. Tighten until the arms are firmly clamped.

Required Hardware:

  • 3x M4 screws (Length: 6mm is enough, 10mm also works)

  • 3x M4 nuts

Print Settings:

  • Material: PETG or ASA (Recommended due to the heat from the light bulb—do not use PLA).

  • Walls: 3 or 4 perimeters for strength around the bolt holes.

  • Infill: 20% (Gyroid or Cubic).

  • Supports: No.

Tagi