Ventilation Grille for Official Prusa MINI Enclosure REMIX with Magnet
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
A top vent for the MINI enclosure. Inspired by the CORE One.
- Ocena
- 5 / 5
- Polubienia
- 4
- Pobrania
- 10
- Wydruki
- 1
- Wyświetlenia
- 68
- Oceny
- 1
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Prusa Parts & Upgrades
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
I added 5x3mm or 5x2mm magnets to keep the grids either fully open or fully closed, and I added a small piece to cover the small hole that was visible when the grids were closed
The magnets should not be past with glue, simply tap them into place with a flat-headed hammer to avoid damaging the printed part, and be sure to orient the magnet correctly.
Everything else is as @reiji_84228 said. You can also print it in PLA, but it will be fragile. I printed it with Sunlu PLA+ 2.0, which is a bit sturdier than classic PLA.
And I recommend the 3D honeycomb filling
We'll see how it goes with time