Ventilation Grille for Official Prusa MINI Enclosure REMIX with Magnet
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
A top vent for the MINI enclosure. Inspired by the CORE One.
- Rating
- 5 / 5
- Likes
- 4
- Downloads
- 10
- Makes
- 1
- Views
- 68
- Reviews
- 1
Updated at source:
Model information
- Source
- Printables
- Category
- Prusa Parts & Upgrades
- License
- Creative Commons — Attribution — Noncommercial — Share Alike
I added 5x3mm or 5x2mm magnets to keep the grids either fully open or fully closed, and I added a small piece to cover the small hole that was visible when the grids were closed
The magnets should not be past with glue, simply tap them into place with a flat-headed hammer to avoid damaging the printed part, and be sure to orient the magnet correctly.
Everything else is as @reiji_84228 said. You can also print it in PLA, but it will be fragile. I printed it with Sunlu PLA+ 2.0, which is a bit sturdier than classic PLA.
And I recommend the 3D honeycomb filling
We'll see how it goes with time