CMF Phone 2 Pro Case - PETG

After finding that there were no cases for the CMF Phone 2 Pro that both protected the screen of the phone and looked good, I decided to make my own case. It fits the phone perfectly (as long as you shove it a bit) and doesn't fall off like your grades do after a party. It's designed to keep bulk as low as possible while still offering edge protection and structural rigidity. 

The design leaves the back exposed and focuses on a tight, precise fit with very thin walls. It pairs with CMF’s official camera ring system and includes separate printable parts for added modularity.

I modified CMF's official camera rings to be slightly slimmer and not have the notches for a camera attachment I'll never use. The case is still compatible with the official camera rings. 

Features:

• Extremely thin walls for a low-profile feel

• Very tight press-fit for secure retention

• Open-back design (no rear coverage)

• Compatible with CMF official camera rings

• Clean, minimal aesthetic

Print Settings:

• Material: PETG recommended

• Walls: 2 perimeters

• Supports: Not required

• Standard layer heights (0.2 mm works well)

Assembly:

• Print the main case body

• Print the camera ring and accessory point cover separately

• Press-fit all components into place. You can figure out how it all goes together. 

Notes:

• Fit is intentionally very tight. PETG is recommended for its slight flexibility during installation

• Due to the thin walls and open-back design, this case prioritizes minimalism over heavy-duty protection

• Install carefully to avoid stressing the print