Molex MicroFit Panel Mount template for remixing into other models
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Proper housing for Molex MicroFit 3.0 panel mount plug housings with the intent to be used for remixing other models.
- Ocena
- 0 / 5
- Polubienia
- 5
- Pobrania
- 42
- Wydruki
- 0
- Wyświetlenia
- 173
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Electronics
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
When I needed to mount some Molex MicroFits I came here.....but the only thing I found were jury-rigged solutions that included a retaining screw on the back. I have been accused of being fussy before... and when dealing with expensive equipment, I like to keep extraneous metal away from my contacts.
That is why I made a proper mount for the proper housing with the Molex provided models using the retention clips on the housing that can be easily adapted for remixing other projects.
I will likely only be doing the 6 pin and and the 4 pin.
4 pin - Molex Part Number - 0430200400
6 pin - Molex Part Number - 0430200608
The tolerances are pretty tight. So I would recommend a .25mm first layer and Classic walls. Arachne rounded things far too much.
That said, there are of course limitations as there is only 1 orientation in which there aren't internal overhangs that could be difficult to overcome with such tolerances.