Molex MicroFit Panel Mount template for remixing into other models
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Proper housing for Molex MicroFit 3.0 panel mount plug housings with the intent to be used for remixing other models.
- Rating
- 0 / 5
- Likes
- 5
- Downloads
- 42
- Makes
- 0
- Views
- 173
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Electronics
- License
- Creative Commons — Attribution — Noncommercial — Share Alike
When I needed to mount some Molex MicroFits I came here.....but the only thing I found were jury-rigged solutions that included a retaining screw on the back. I have been accused of being fussy before... and when dealing with expensive equipment, I like to keep extraneous metal away from my contacts.
That is why I made a proper mount for the proper housing with the Molex provided models using the retention clips on the housing that can be easily adapted for remixing other projects.
I will likely only be doing the 6 pin and and the 4 pin.
4 pin - Molex Part Number - 0430200400
6 pin - Molex Part Number - 0430200608
The tolerances are pretty tight. So I would recommend a .25mm first layer and Classic walls. Arachne rounded things far too much.
That said, there are of course limitations as there is only 1 orientation in which there aren't internal overhangs that could be difficult to overcome with such tolerances.