GMKtec M6 Ultra Vesa Mount (100x100 Snap-Fit)
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Wstępna wycena dla PETG
1,02 € – 1,24 € netto (bez VAT)
Dla pliku: GMKtec_M6_Ultra_100x100_with_loop_PETG_36m20s.gcode
To wstępna wycena jednego pliku. Dokładną cenę poznasz przed zamówieniem.
Plik i założenia wyceny
Plik użyty do wyceny
Średnia wycena orientacyjna: 1,13 € netto (środek widełek).
- Masa podana przez autora
- 27 g
- Czas druku podany przez autora
- 36 min
- Materiał u źródła
- PET
- Materiał wyceny
- PETG
- Drukarka wyceny
- Bambu Lab P1S - 0.4 nozzle
- Proces wyceny
- 0.20mm Standard
Orientacyjna wycena wyłącznie wybranego pliku, oparta na masie i czasie druku podanych przez autora. Warianty plików nie są sumowane. Ostateczna cena zostanie obliczona po analizie pliku.
Zapisane na tym urządzeniu.
Minimalist 100x100 VESA mount for GMKtec M6 Ultra. Snap-fit design preserves rubber feet. Optimized for PETG printing.
- Ocena
- 0 / 5
- Polubienia
- 1
- Pobrania
- 20
- Wydruki
- 0
- Wyświetlenia
- 196
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Computers
- Licencja
- Creative Commons — Attribution
I designed this minimalist VESA mount because I couldn't find an existing option that felt secure without requiring the removal of the rubber feet. This bracket features a high-clearance design that snaps directly onto the unit for a clean, professional setup.
Key Design Features
Zero-Tolerance Snap-Fit: Designed to grab the bottom edge of the M6 Ultra chassis securely. There is no wiggle room once seated.
No Hardware Modification: The mount is spaced to accommodate the original rubber feet so you don't have to peel them off.
Correct Orientation: The open side is intended for the cables and power button. Note: The unit will only snap in securely when oriented this way; the opposite side will not lock in properly.
Thermal Management: The large center cutout ensures maximum airflow to the bottom of the PC.
Print Settings
Material: PETG is highly recommended. It provides the necessary "spring" for the snap-fit and handles the heat of the PC better than PLA.
Walls: 4 Wall Loops (Perimeters). This is critical for the strength of the clips and the mounting loop.
Infill: 20% (I used 35% modifiers specifically around the VESA holes for extra compression strength).
Supports: None. Print it flat on the backplate.
Hardware & Customization
VESA Pattern: 100mm x 100mm.
Screws: The 4mm holes with 5mm countersinks are a perfect fit for either M4 or standard
6-32 screws.Makers Note: If you want to use larger hardware, you can add cylindrical modifiers in your slicer over the holes at 100% infill to resize them without losing structural integrity.