Emergency Stop for Voron Trident or 2.4
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Skirt button holder and macro
- Ocena
- 5 / 5
- Polubienia
- 9
- Pobrania
- 9
- Wydruki
- 1
- Wyświetlenia
- 127
- Oceny
- 1
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Voron Parts & Upgrades
- Licencja
- Creative Commons — Attribution — Noncommercial
I wanted a reliable Emergency stop button for my Voron
Not wanting to get too creative on something so important I bought a reliable button
https://www.aliexpress.com/item/1005004176517786.html
16mm diameter
The print contains 2 parts, one front, one back, to allow the button to be mounted to a Voron Skirt
Once you've done that you need to wire it up
I suggest wiring it between Ground and a GPIO pin on your Pi. You can use any GPIO pin (see https://pinout.xyz/) Sadly this does normally involve getting the crimpers out
Wire it as push-to-break so any wiring issue will trigger the emergency stop too. Then add to your moonraker.conf
[button estop]
type: gpio
pin: gpiochip0/gpio17on_press:
{% do call_method("printer.emergency_stop") %}
switch gpio17 for the number of your chosen GPIO