Dessicant box for 20l drybox

I drew this in about an hour. It's a simple box that uses gyroid infill to retain a lot of silica for my 20l dryboxes. The short boxes hold ~260g and you can fit 2 on each side, for a total of 4. I'm running these one per drybox right now as I'm still printing them. The short ones use about 100g of filament including the lid.

Use 2-3 walls and 10-15% infill on whatever print profile you're happy with, 0 perimeters, 25% gyroid infill for the mesh modifier parts.

If you're loading the bare STLs not the 3mfs it's essential you split them to parts and change the type of the smaller part to a modifier mesh, and set the perimeters to zero and the infill to 25% gyroid. This is already done in the 3mfs. You can change the printer, profiles and filament and they should still work.

The long version needs a 280mm Z height to print, so multiples of the short version are probably easier. I modelled the lid solid so you can fill the whole container rather than having a gap at the top. With 15% infill and 3 walls it prints faster and uses less filament than having a lid with a lip.

it's intended to work with the dryboxes I made pipe mounts for. 

The included fusion file has the pipe roller stuff in it as well.

I'm no longer printing the angled PC10 mounts, instead I recommend using the entirely printable glands designed for this 2 spool drybox