Panda Breath Voron Trident 300/350 Mount
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Biqu Panda Breath Mount for Voron Trident 300 and Voron Trident 350
- Ocena
- 0 / 5
- Polubienia
- 10
- Pobrania
- 26
- Wydruki
- 0
- Wyświetlenia
- 501
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Voron Parts & Upgrades
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
This Mount is only for Voron Trident 300 and Voron Trident 350, the 250 version isn't supported due to lack of space.
BOM:
Basemount: 2 pc. M3 x 8 shcs 2 pc. M3 Hammerhead or Roll-in-nut
Topmount: 1 pc. M3 x 12 bhcs, 1pc. M5 x 20 bhcs
Bracket: 1 pc. M5 Nut, 1 pc. M5 x 12 bhcs, 1 pc. M5 Hammerhead or Roll-in-nut
Installation:
Install Topmount to Breath using the M3 x 12 bhcs, its screwed directly into the plastic. Before installing the basemount you should decide how you like to route the cable, its possible to run the cable all through the basemount to the right wireduct or you can also drill an 8mm hole through the back panel. After preparing basemount install bracket but don't fix it until Panda breath is clipped in and Bracket is positioned correctly.
For use with LDO 300 Cube use the longer bracket
Important Note for Trident 300:
As mounting space is pretty close on Voron Trident 300 its absolutely neccessary to replace the back Z-Carriage with the ones provided here to avoid damaging of the Breath Power Cable!!!
CHECK CLEARANCE AFTER INSTALLATION