Voron design cooler master pump cover for displaying light objects

Cover designed for the Cooler Master: Elite Liquid custom pump covers contest. designed to look like Voron Design made it. Perfect for a pc with a black case and red ARGB or LED lights. The RGB on the cooler will shine beautifully through the holes. It has a stand you slide on/fold down to display your favourite reasonably light object/print

Build instructions

1: chose either the hexagon or simple base design.

2: locate the 2 pipes/holes next to eachother.

3: cut off 2 pieces of bendable (but sturdy like pla+) filament around 15cm (6 inch).

4: slide the filament into the holes.

5: locate the holes on the display table, and orientate it so you can see the logo properly.

6: slide the display table so the filament slides into the table, and cut off exces filament.

Settings should generally not matter too much, but I use these:

Infill: 20%

Walls: 2

Filament: abs

Most settings will work fine.

You can also bend the filament so de display table is in front of the base. You have to orientate the table differently for that though, so the logo stays the same.

I have made a 2mm hole for filament and a 2,25/2.25mm version, choose the 2mm version if you are confident that it will fit and you trust that your printer has higher tolerence than .25mm. I printed it with an a1 mini and the 2mm did not work for me with my settings. I didn't make one for the table, as it was a perfect fit.

You do need to check that the seam isn't in the hole for filament, or else the filament won't fit, I learned this the hard way.