1 / 2
Sub250 OasisFly30 Caddx Ratel Micro 1500TVL Camera mount — zdjęcie 1
1 / 2

Sub250 OasisFly30 Caddx Ratel Micro 1500TVL Camera mount

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

A mount for the Caddx Ratel Micro 1500TVL FPV camera to fit the Sub250 OasisFly30.

Ocena
0 / 5
Polubienia
0
Pobrania
5
Wydruki
0
Wyświetlenia
75
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Kategoria
Electronics
Licencja
Creative Commons — Attribution — Noncommercial — Share Alike

Disclaimer: I used AI for the markdown formatting, but it did not do anything else. I wrote and checked all the instructions myself.

A mount for the Caddx Ratel Micro 1500TVL to fit the Sub250 OasisFly30.

The camera angle is fixed around 30 degrees.

What's required:

- 1x Cam_Bottom_Mount.stl

- 1x Cam_Top_Mount.stl

- 2x Washers.stl (I used nylon washers but provided 3D printed ones which should work just as well)

- 2x M2x8mm screws (I used the spare ones that came with the drone)

Install instructions:

1. Check the guide (Photo 2) for a visual guide.

2. Remove the top plate.

3. Screw in the Cam_Bottom_Mount using the 2x M2x8mm screws.

- Use the washers so the screws don't slip through the holes (see photos for placement).

4. Place the camera in.

- Make sure the connectors on the back face the bottom of the drone. I recommend plugging in the wire now.

5. Snap the Cam_Top_Mount on top of the camera.

- Make sure the camera hasn't rotated, or else the top won't fit.

6. Reinstall the top plate.

Tagi