Liczymy pasujące modele…
Sub250 said that the Huma was only suitable for the DJI 03, however just two parts are required to fit a Walksnail Moonlight as well as some 30mm (M2) standoffs and two 10mm x M2 bolts.
for mounting GPS receiver on quadcopter drone on the nose over the FPV camera FITS: Lumenier QAV-S 2 Sub250 Joshua Bardwell SE 3in frame link HGLRC M100_Mini GPS link MATERIALS: TPU 95A (optional) M3x6 or M3x8 screws (4 each) PRINTING…
Sub250 Oasisfly25 BZGNSS BZ-121 GPS mount TPU. Printed in TPU 95A.
Sub250 Oasisfly25 o3 antenna mount. Printed in TPU 95A.
This model is a printable replica of the foam bumpers that come with the quad. I have been flying and crashing a ton with these installed with double sided 3M tape and they still appear undamaged. As for print instructions -Filament: TPU…
Dji o3 mount distance for Sub250 Oasisfly25. Allows you to mount the DJI o3 horizontally. Without it, you can't tighten the screws on the unit all the way. Print 4 pieces. Printed in PETG.
Mum, look! This battery has a drone! The goal of this project was simple – take two 21700 Li-Ion batteries and build a drone around it, trying to maximize efficiency. This meant a lightweight frame and large propellers, as the batteries…
Various 3D Scans of my OasisFly30 used to make some 3D models, uploading in case anyone else has a need for them. The camera in the scans is the Caddx Ratel Micro 1500TVL. Warning Some of these scans have parts I've added to the drone…
Rear dual antenna mount for receiver (RP1) and VTX antennas with a swappable VTX antenna SMA connector. Printed in TPU with a brim for adhesion. It has survived quite a few falls, so I thought I would share.
BACKSTORY: I created replacement back arms for the Sub250 Oasisfly35. The idea came from an FPV group, after I was looking for suggestions for a frame replacement. One person suggested to just print the legs, as the body is still strong…
Disclaimer: I used AI for the markdown formatting, but it did not do anything else. I wrote and checked all the instructions myself. A mount for the Caddx Ratel Micro 1500TVL to fit the Sub250 OasisFly30. The camera angle is fixed around…
A TPU print that allows you to run the Flywoo O4 ND Filters on your Sub250G Pro Turtle. Just be careful when removing the ND filter, because it is only held on by small TPU nubs that can tear off!
Rear dual antenna mount for receiver (RP1) and VTX antennas with a swappable VTX antenna SMA connector. Printed in TPU with a brim for adhesion. It has survived quite a few falls, so I thought I would share.
Sub250 Nanofly20 HD O4 Battery Mount Battery Size: 30.5mm x 17mm x 69.5mm Support: Tree Support
