Engraved Wind Chimes - Hummingbird in the Garden
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
A 6-piece engraved wind chime set depicting a hummingbird in a garden.
- Ocena
- 0 / 5
- Polubienia
- 37
- Pobrania
- 57
- Wydruki
- 0
- Wyświetlenia
- 421
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Outdoor & Garden
- Licencja
- Creative Commons — Attribution — Noncommercial
Printing
Chimes: print in the default orientation. A brim may be useful, as they are tall and thin. A minimum of 3 vertical walls will make them completely solid. As pictured below, the tallest chime is 258.8mm (10-3/16 in) tall. Scaling down the Z should work fine, though be aware this will compress the holes at the hang point.

Top support: print in the default orientation. Supports on build plate will be helpful to avoid the long bridges.
Striker & wind sail: print in the default orientation. A higher infill percentage will help give these more weight, if needed.

Construction Tips
Any type of string, twine, or cord can be used to hang these wind chimes. For ease of construction, I would recommend using nylon cord no larger than 2mm in diameter.
For each chime, run the cord through both holes at the hang point, then through the tunnels on the underside of the top support before tying a knot to hold the chime in place. Each chime should be centered directly beneath one of the "petals":


The same concept applies to the striker, which is suspended from the hook on the underside of the top support:

Ideally, the striker should hang near the bottom of each chime. I recommend adjusting the amount of cord for each chime so that they are all aligned at the bottom, and arranging the chimes so that their weight is distributed along the entire support:


(See more graphics and info about wind chime construction on Lee Hite's website)
Finally, use cord to hang the entire apparatus from a hook or other hanger using the tunnels on the very top, ensuring the entire thing is level:

Remixes and Attribution
Feel free to use any part of this model in your own models and remixes with attribution. I think the engraved chimes would look wonderful in any other 3D-printed wind chime setup. No commercial use allowed.
Floral patten SVG from vecteezy.com.
Construction tips from Lee Hite's 'Chime Design & Build' website: https://leehite.org/Chimes.htm