TwinVortex Dual Fan Cooling Mod for S300
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Dual 120 mm external cooling mod for the S300, designed to improve airflow and lower temperatures in a compact ITX build
- Ocena
- 5 / 5
- Polubienia
- 3
- Pobrania
- 6
- Wydruki
- 1
- Wyświetlenia
- 100
- Oceny
- 1
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Computers
- Licencja
- Creative Commons — Attribution
This is a custom dual 120 mm external fan bracket designed for the S300 ITX case. I created it to improve airflow and cooling performance in a very compact build where internal space is limited. The design mounts two fans externally and uses a vortex-inspired grill pattern for both protection and aesthetics. It was made as both a functional cooling upgrade and a custom case mod for my own build.
To install the shroud:
Install a low profile 120 mm fan inside each shroud. The fan mounting holes should align with the holes on the shroud. Route the wires as you like, but there is a small opening at the back so the front fan wires can pass into the rear shroud. I also added a compartment in the rear shroud to store the wiring and connections, effectively hiding most of the cables.
Use the drill guide provided to align and mark the holes, then drill where you want to mount it on the S300. (Yes, you do have to drill. Sorry...)
Mount the assembled shrouds onto the outside of the S300 side panels using M4 screws and nuts. I recommend using anti slip rubber washers.
Connect the fans to the motherboard or fan hub and set the desired fan curve.