1 / 3
Ultra-Slim 60/90/120 cm LED Batten Mount (V-TAC, Ledvion, Hoftronic) — zdjęcie 1
1 / 3

Ultra-Slim 60/90/120 cm LED Batten Mount (V-TAC, Ledvion, Hoftronic)

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

Replacement mount for ultra-slim LED batten fixtures with semi-round diffuser.

Ocena
0 / 5
Polubienia
2
Pobrania
12
Wydruki
0
Wyświetlenia
79
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Licencja
Creative Commons — Attribution — Noncommercial

Ultra-Slim LED Batten Mount — V-TAC / Ledvion / Hoftronic compatible

Replacement mount for ultra-slim LED batten fixtures with semi-round diffuser. The included OEM clips are flimsy and tend to slip — this print holds the batten tight and stays put.

Two versions

  • V1 — with cable cutout on the back (clearance for quick-connector / wiring)

  • V2 — no cutout (clean fit)

Compatibility

Fits ultra-slim LED battens with semi-round diffuser profile:

  • Profile: ~25 mm height × 33–35 mm width

  • All standard lengths: 30 / 60 / 90 / 120 / 150 cm (mount is length-independent)

  • Verified on: V-TAC Ultra-Slim 60cm 20W

  • Very likely also fits: Ledvion, Hoftronic and similar generic ultra-slim variants with matching profile

Measure your batten's cross-section before printing to confirm fit.

Print settings

⚠ PLA not recommended — LED battens generate heat during operation; PLA deforms above ~55°C. ✅ Recommended materials: PETG, ASA, ABS, or any heat-resistant filament.

  • Perimeters: 3+

  • Infill: 30%+

  • Layer height: 0.2 mm

  • Supports: not required

⚠ Disclaimer — use at your own risk

This is a 3D-printed mount, not a certified lighting accessory. Test mechanical strength and secure installation before use. The designer accepts no liability for damage, fixture detachment, fire, or injury resulting from use of this part. You are responsible for safe installation.

Tagi