Ultra-Slim 60/90/120 cm LED Batten Mount (V-TAC, Ledvion, Hoftronic)
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Replacement mount for ultra-slim LED batten fixtures with semi-round diffuser.
- Rating
- 0 / 5
- Likes
- 2
- Downloads
- 12
- Makes
- 0
- Views
- 80
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Other House Equipment
- License
- Creative Commons — Attribution — Noncommercial
Ultra-Slim LED Batten Mount — V-TAC / Ledvion / Hoftronic compatible
Replacement mount for ultra-slim LED batten fixtures with semi-round diffuser. The included OEM clips are flimsy and tend to slip — this print holds the batten tight and stays put.
Two versions
V1 — with cable cutout on the back (clearance for quick-connector / wiring)
V2 — no cutout (clean fit)
Compatibility
Fits ultra-slim LED battens with semi-round diffuser profile:
Profile: ~25 mm height × 33–35 mm width
All standard lengths: 30 / 60 / 90 / 120 / 150 cm (mount is length-independent)
Verified on: V-TAC Ultra-Slim 60cm 20W
Very likely also fits: Ledvion, Hoftronic and similar generic ultra-slim variants with matching profile
Measure your batten's cross-section before printing to confirm fit.
Print settings
⚠ PLA not recommended — LED battens generate heat during operation; PLA deforms above ~55°C. ✅ Recommended materials: PETG, ASA, ABS, or any heat-resistant filament.
Perimeters: 3+
Infill: 30%+
Layer height: 0.2 mm
Supports: not required
⚠ Disclaimer — use at your own risk
This is a 3D-printed mount, not a certified lighting accessory. Test mechanical strength and secure installation before use. The designer accepts no liability for damage, fixture detachment, fire, or injury resulting from use of this part. You are responsible for safe installation.