Flower from Flower, Sun, and Rain logo
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Flower from Flower, Sun, and Rain logo
- Ocena
- 0 / 5
- Polubienia
- 0
- Pobrania
- 2
- Wydruki
- 0
- Wyświetlenia
- 17
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- 2D Plates & Logos
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
The flower from the Flower, Sun and Rain logo.
Traced directly from the logo. Because of this the model itself turned out to be pretty big and realized too late. In any case, scaling it down in the slicer and some tweaking resulted in a good enough result.
I made 4 variations:
Flower with base and keyring
Flower with base and no keyring
Flower without base and keyring
Flower without base nor keyring
No keyring versions could be nice for magnets for example.
Made with Elegoo's PLA Silk for green and red colours, PLA Galaxy for black, and orange was regular PLA since I didn't have anything else :P
Printing settings:
Scale: 24%
Slicing mode: Close holes
Infill pattern: Grid
Ironing (optional):
Speed: 60mm/s
Type: All top surfaces
Flow 30%
The piece in the picture was made with Close holes mode and ironing, you may try without ironing if PLA Silk since it takes away it's shiny look, Whatever you do, keep Close holes mode, otherwise the print may have a lot of gaps (at least judging from how the slicer renders it)