LayersFactory
Zgłoś model
1 / 3
Parametric Balance Board for Skateboard Deck or Scrap Plywood — zdjęcie 1
1 / 3

Parametric Balance Board for Skateboard Deck or Scrap Plywood

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

Plainworks

Plainworks

@Plainworks

Bolt on balance board sphere and adapter plate for old skateboard decks or scrap plywood. Fully parametric.

Ocena
0 / 5
Polubienia
2
Pobrania
8
Wydruki
0
Wyświetlenia
72
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Kategoria
Indoor Sports
Licencja
Creative Commons — Attribution — Noncommercial
SzczegółyPliki (3)Wydruki i komentarze (Wydruki: 0) (Komentarze: 0)Remiksy (0)Kolekcje (5)Powiązane

Balance board attachment that can be bolted onto any old skateboard deck or just straight onto a scrap piece of plywood. Tested weight capacity at 200 lbs on an 8" skateboard deck and it works really well. It is fun to use at a standing desk. The uploaded stl and 3mf files are for an 8" skateboard deck with a .428" concave.
The model is parametric so you can add a couple dimensions from your own deck and it should fit perfectly. Uses standard skateboard hardware, 1" screw length.

To fit to your deck:

  • Make your own copy of the Onshape file here

  • Input your deck width and concave in the input_vars tab at the bottom of page. 

  • Sphere height and diameter can be changed for adjusting difficulty if desired.

  • After printing, you will need to drill and countersink the bolt pattern in the center of your deck.

Variable

Rec. Range

Req.

Description

board_width

N/A

Y

Deck width

board_concave

N/A

Y

This can be measured by placing a straight edge across the width of the deck on the topside, then measuring the gap between the straight edge and the top of the deck in the middle of the deck.

sphere_height

1.5" - 2.0"

N

height of partial-sphere from the bottom of deck to the bottom of the dome.

sphere_diameter

6" - 8"

N

diameter across the face of the top of the dome.

Note: The dome part could be bolted straight onto any piece of plywood without the adapter plate instead of using a skateboard deck.


Print Settings:

  • PLA

  • .2 mm layer height

  • 3 Wall loops, 5 top layers, 4 bottom layers

  • 15% infill, tri-hexagon pattern

  • 100% infill around the bolt holes (check 3mf for modifiers)

  • Supports: none

Tagi

deskboardbalancewoodworkingworkoutskateboardwobbleplywoodonshapeexercisefitnessstanding