Waveshare 2.8in Round Screen Mount for Delonghi ECP Machines

Waveshare 2.8in round screen mount to mount it to the Delonghi ECP3630 Espresso machine.

Should also fit on other Delonghi ECP Machines, but unsure. Print is broken into 3 parts for ease of printing

I print the Outer adapter on it's face with no supports, the shroud with the solid side down, no supports, and the inner adapter with supports.

Hardware Needed:
- 4 M2x6mm screws
- 4 M2 Washers
- 2 M3X12mm screws
- 2 M3 Washers
- 2 M3 Nuts 
- A bit of superglue

Wire the Screen up first
- Take two m3 nuts, and glue them into the openings on the inner adapter. 
- Screen is mounted to the inner adapter with M2x6mm screws with washers, route wires through the center opening.
- Inner adapter and screen fits into the shroud. There is a cutout for the bottom of the screens motherboard. Screen will be almost flush with the edge, there is a small lip that will retain the edge of the screen.
- Fit outer adapter to the ECP3630, it is designed for the original face place to be used. Remove the machine dial fully, place on the adapter and thread the M3 screws with washers from inside the espresso machine. 
- Slide on the shroud and screen assembly onto the M3 screws and tighten from the inside of the machine.

And you are done.

Updated shroud. Install as described, but the outer shroud now snaps on, making full install much easier. Will update instructions after the entire design is redesigned, making total changes to make install much smoother.