Coax Cable Stripper for Neutrik NBNC75BLP9
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Custom 3D-printable coax cable stripping tool designed specifically for preparing cables for the Neutrik BNC connector
- Ocena
- 0 / 5
- Polubienia
- 1
- Pobrania
- 10
- Wydruki
- 0
- Wyświetlenia
- 112
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Electronics
- Licencja
- Creative Commons — Attribution
Custom 3D-printable coax cable stripping tool designed specifically for preparing cables for the Neutrik NBNC75BLP9 connector.
The tool uses 3 small blade segments broken off from a standard utility knife.
Each blade is positioned at a different depth to create the required cuts for the connector preparation.
Designed cutting depths are optimized for:
Sommer Cable Vector 0.8/3.7 sw
Neutrik NBNC75BLP9
To use:
Insert the cable
Rotate the tool or the cable
The blades cut around the cable at the preset depths
Hardware Required
1× M4x40 countersunk screw (Senkkopf)
2× M4x30 screws
3× M4 nuts
Blade Installation
The blades are clamped into the printed parts.
If the blades are not held tightly enough, you can place a small piece of tape behind the blade to improve clamping.
For crimping the connector, I can recommend:
T3698A BNC coaxial crimping tool