Mikrotik LHG Aiming Harness
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Aiming Alignment Azimuth Harness to provide a space to put your phone while aiming the LHG while mounting on a pole.
- Ocena
- 0 / 5
- Polubienia
- 0
- Pobrania
- 5
- Wydruki
- 0
- Wyświetlenia
- 65
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Other Ideas
- Licencja
- Creative Commons — Attribution
A model for helping to aim a Mikrotik LHG antenna. Designed to screw into the holes for the advanced mounting kit and provide a place to put a phone with a compass app so you can see (relatively) accurately the orientation in degrees.
If you're mounting to a pole, the holes are free and this shouldn't be an obstruction. If you're using the advanced mounting kit I think it should work fine too, but you'll probably need longer bolts.
If you're pole mounting, you can print the bolts (https://www.printables.com/model/946965-m6-bolt-and-nut-6-variations-tolerance-test) since it's not really load bearing.
As for filament choices, if this is a one and done installation, PLA will be fine, but it will probably deform in the sun and heat over time so if you think you'll need to go back to it later, PETG or ASA is probably better. That said, my PETG tests had some slight oozing issues so the bolt holes were a little tight as was the overall fit.
I've included the original Shapr3D design files if someone wants to tweak it. There's one file where all the objects are joined together (Union) and the base file with all of the individual objects.