IKEA Tisken shower hose mod
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Shower hose hanger mod for the IKEA Tisken suction cups
- Ocena
- 0 / 5
- Polubienia
- 1
- Pobrania
- 7
- Wydruki
- 0
- Wyświetlenia
- 48
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Bathroom
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
I have a long shower hose and keeping it from the shower floor has been hard with a standard Tisken hanger because the flat surface of its hanger part didn't hold the hose. This mod is designed for a hose with a 14mm outside diameter, and a 12.5mm diameter inside the grooves. The model contains 3 ridges which fit into the periodic grooves on the hose for maximum hold.
Print with 0.2mm layer height, flip the model so the U-shape is upside down (looks like a bridge), using supports on the build plate. I also set 4 perimeters both horizontally and vertically to make it a bit more water tight.