Garden stake connector for plastic coated steel stakes
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
This connector allows 11 mm plastic coated steel stakes to be attached to each other at 90 degree angles.
- Ocena
- 0 / 5
- Polubienia
- 89
- Pobrania
- 172
- Wydruki
- 1
- Wyświetlenia
- 918
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Outdoor & Garden
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
I made these to connect the plastic coated garden stakes that have bumps on them to hold tape or ties. The vertical part is split to allow it to slide over the stake and the horizontal part is open so the stake can be pushed into it and hold the split together tight on the vertical stakes. I printed them out of PLA+ with 35% TPMS-D infill but whatever your favorite outdoor filament will work fine probably. The holes are 11 mm so they could be scaled to fit your stakes based on that dimension.


