Minimalist Strap Buckle / Ribbon Fastener (10mm)
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Minimalist buckle for 10mm ribbons. Turn any fabric strap into an ergonomic wristband using a secure friction lock.
- Ocena
- 5 / 5
- Polubienia
- 2
- Pobrania
- 30
- Wydruki
- 1
- Wyświetlenia
- 92
- Oceny
- 1
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Other Fashion Accessories
- Licencja
- Creative Commons — Attribution
Specifications
Compatible Strap Width: 10 mm (with 0.5 mm tolerance on each side)
Strap Thickness: up to 1.8 mm
Dimensions: Very small, lightweight, and low-profile
How to use
Insert: Take one end of your ribbon/strap and push it from the bottom side up through Slot 1 (outer slot).
Weave: Pass the ribbon over the first inner bar, and push it down through Slot 2 (middle slot).
Lock: Pass it under the second inner bar, and push it up through Slot 3 (the last outer slot).
Tighten: Pull the ribbon to adjust the size on your wrist. The wave geometry creates a natural friction lock. The harder you pull, the tighter it holds!
3D Print Settings
Material: You can use PLA, but PETG is better because it is more durable.
Supports: NO supports needed. Print flat side down.
Infill: You should use strong infill, because it is a small part, and it will make it more resistant.
Quality: 0.15 mm - 0.20 mm = Lower layer height makes the inner slot edges smoother so the fabric doesn't snag. But it is ok to use Prusa DRAFT settings