1 / 4
Minimalist Strap Buckle / Ribbon Fastener (10mm) — image 1
1 / 4

Minimalist Strap Buckle / Ribbon Fastener (10mm)

Order a print of this model

We calculate the final price from your selected file. You review and accept it before payment.

Saved on this device.

Minimalist buckle for 10mm ribbons. Turn any fabric strap into an ergonomic wristband using a secure friction lock.

Rating
5 / 5
Likes
2
Downloads
30
Makes
1
Views
92
Reviews
1

Updated at source:

Model information

License
Creative Commons — Attribution
Specifications
  • Compatible Strap Width: 10 mm (with 0.5 mm tolerance on each side)

  • Strap Thickness: up to 1.8 mm

  • Dimensions: Very small, lightweight, and low-profile

How to use
  • Insert: Take one end of your ribbon/strap and push it from the bottom side up through Slot 1 (outer slot).

  • Weave: Pass the ribbon over the first inner bar, and push it down through Slot 2 (middle slot).

  • Lock: Pass it under the second inner bar, and push it up through Slot 3 (the last outer slot).

  • Tighten: Pull the ribbon to adjust the size on your wrist. The wave geometry creates a natural friction lock. The harder you pull, the tighter it holds!

3D Print Settings
  • Material: You can use PLA, but PETG is better because it is more durable.

  • Supports: NO supports needed. Print flat side down.

  • Infill: You should use strong infill, because it is a small part, and it will make it more resistant.

  • Quality: 0.15 mm - 0.20 mm = Lower layer height makes the inner slot edges smoother so the fabric doesn't snag. But it is ok to use Prusa DRAFT settings

Tags