1 / 15
Amateur Radio V Antenna (positive V) — zdjęcie 1
1 / 15

Amateur Radio V Antenna (positive V)

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

This is the central portion of a V Antenna for Ham Radio, with 5.6m whips it covers from 6m to 20m.

Ocena
0 / 5
Polubienia
0
Pobrania
11
Wydruki
0
Wyświetlenia
88
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Kategoria
Other Gadgets
Licencja
Creative Commons — Attribution — Share Alike

This will cover (using 5.6m whips available in many shops) from 20m down to 6m bands just by changing the whip sizes and checking the resonance using a VNA or similar.

120 degrees for match close to 50ohm and slightly more gain than a straight dipole. (Also a bit of directionality)

Space for a choke using a FT-140 43 and some coax. 

This is for portable use, I bought a photography tripod off one of the online Chinese shops and made a small interface between the tripod screw and M10.

The holes for the whips are larger to allow putting some extenders before the whips as I plan to make some coils and use this antenna up to 40m, a small adapter is also provided to use the whips without the extenders. (Coils available at the bottom)

Some vitamins are required:

  • metal inserts (M2.5) for the lid (even though the lid is not essential)

  • Screws for the lid (M2.5)

  • Two M10 bolts to screw the whips on (I used copper covered ones, made it easy to solder the coax)

  • Some glue to fix the bolts in place, expoxy is better, just make sure none gets on the threads

  • A FT-140 43 toroid to make the choke

  • Some thin coax to make the choke (I used RG-316)

  • I used a N type connector, by what ever you prefer is ok, should fit PL or N type.

  • Two 5.6m whips available in many shops, if you buy some extra 2.5m ones it's possible to cover the 2m and 4m bands as well, but for 2m there are better antennas out there.

  • Solder, bits of coper wire to connect the bolts to the coax

  • M10 rod

  • M10 Bolts to secure the rod so it doesn't rotate in the wind.

Very happy with this antenna, very portable and very easy to get a perfect match in the bands supported, SWR is only really dependent on location (higher near buildings, etc), but in the field it's always excelent (1.1 or lower). After a few trips out I marked the locations on the whips for each band and that makes it really quick to set up. (some tuning still needed to be made to account for location, but only a couple if you're looking for a perfect match).

Played around some more with this antenna, and it works really well on all the bands, but was surprised I could find some good resonances on 2m and 70cm as well, I'm sure the pattern is all weird, but receives well and super low swr as well, works well in a pinch in needed.


Used it for POTA many times now, very fast to adjust (after you have the places marked). Quite light to carry. Been using with a 5m tripod. Got a lot of contacts on SSB, furthest was Australia (from Portugal) using 100w. Rotating it lets you get some gain (or run away from some noise), but not really necessary.

Tagi