1 / 19
Anytone AT-D890UV / AT-D878UVII-Plus radio holder NO play, snug hold — zdjęcie 1
1 / 19

Anytone AT-D890UV / AT-D878UVII-Plus radio holder NO play, snug hold

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

All holders I found were loose so I iterated 5 times to have a snug fitting on the radio, but easy removal.

Ocena
0 / 5
Polubienia
6
Pobrania
34
Wydruki
0
Wyświetlenia
203
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Kategoria
Electronics
Licencja
Creative Commons — Attribution — Noncommercial — Share Alike

Hey ya'all,

All holders I found were loose so drew and I iterated 5 times to make a prefect fitting on the radio, but still retain easy removal. This is based on the original battery with the original spring tension belt clip.
I made the charging indicator light and the charging port accessibel also.

I own the AT-D890UV but it should also fit the AT-D878UVII perfectly as well.

I mounted it with 4xM3 bolts with holes printed at 2,75, and I hand tapped to prevent layer splitting. I feel inserts are not required here. Hole patern horizontal 28mm CTC vertical 23,5mm CTC

I also uploaded a bare bones version with no holes so you can edit it to your needs.

-I printed in PETG
-100% infill (resists warping in hot car)
-0.4mm nozzle
-0,2mm layer lines
-I printed with supports, excluding M3 holes
-I printed upright

Tagi