Ikea Pax & Oversidan LED Light cable plug for back panel
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Cable plug for the Ikea Oversidan lights cable through rear panel of Pax wardrobe
- Ocena
- 0 / 5
- Polubienia
- 4
- Pobrania
- 12
- Wydruki
- 0
- Wyświetlenia
- 108
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Other House Equipment
- Licencja
- Creative Commons — Attribution
As part of a new wardrobe Ikea Pax wardrobe installation, my daughter & her partner wanted to use the Ikea Oversidan lights. Ikea advise drilling 8mm holes in any shelves and cabinet tops to route the cables out of the wardrobe. Messy and a lot of work and chances for things to go wrong. Instead we drilled the 8mm hole on the Pax back panel and I designed and printed this blanking plug to make it a neater finish.
Printed on Ender3V2 with 0.4mm nozzle, 0.2 layer height, any infill, PLA+ (eSUN).
The locking tabs can be a bit fragile so I printed a few more than required, since the amount of filament used was minimal as was any extra print time.
I think it's a much neater and simpler solution.