Ikea Pax & Oversidan LED Light cable plug for back panel
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Cable plug for the Ikea Oversidan lights cable through rear panel of Pax wardrobe
- Rating
- 0 / 5
- Likes
- 4
- Downloads
- 12
- Makes
- 0
- Views
- 108
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Other House Equipment
- License
- Creative Commons — Attribution
As part of a new wardrobe Ikea Pax wardrobe installation, my daughter & her partner wanted to use the Ikea Oversidan lights. Ikea advise drilling 8mm holes in any shelves and cabinet tops to route the cables out of the wardrobe. Messy and a lot of work and chances for things to go wrong. Instead we drilled the 8mm hole on the Pax back panel and I designed and printed this blanking plug to make it a neater finish.
Printed on Ender3V2 with 0.4mm nozzle, 0.2 layer height, any infill, PLA+ (eSUN).
The locking tabs can be a bit fragile so I printed a few more than required, since the amount of filament used was minimal as was any extra print time.
I think it's a much neater and simpler solution.