Home Assistant Green 10" 1U Rackmount with Keystone

10" Rackmount for Home Assistant Green (1U) with Keystone Jack

This is a clean, minimalist 1U bracket designed to mount your Home Assistant Green into a standard 10-inch network rack.

The design is engineered to address thermal management, aesthetics, and functionality:

• LED Visibility: The front faceplate features a custom cutout window that showcases the translucent shell and allows you to easily view the status LEDs.

• Passive Cooling: A large honeycomb ventilation grille sits directly above/below the Home Assistant Green's integrated heatsink to ensure optimal airflow and passive cooling.

• Front-Facing Port: Features an integrated keystone jack slot, allowing you to route the Ethernet connection cleanly to the front of your rack.

• Secure Fit: The device mounts directly to the frame using replacement chassis screws and custom 3D-printed spacers for a solid, zero-wobble fit.

📦 Bill of Materials (BOM)

3D Printed Parts

• HomeAssistantGreen10InchRackmount_1x.3mf — The main 1U rack faceplate and mounting tray print file. (Print 1)

• HomeAssistantGreenSpacer_4x.3mf — Custom spacing collar print file. (Print 4)

Hardware

• 4x M3 x 25mm SHCS (Socket Head Cap Screws) — Used to replace the stock enclosure screws on your Home Assistant Green and secure it to the printed shelf.

Cable & Keystone

• 1x RJ45 Keystone Coupler — Standard latching RJ45 keystone coupler (CAT6, CAT6a, or CAT7).

• 1x Short Slim Ethernet Patch Cable — A slim patch cable (approx. 15cm to 25cm in length) to route from the back of the Home Assistant Green to the front keystone.

🖨 Print Settings

• Orientation & Supports: The 3MF print files are already oriented the correct way (face down) for printing. No supports are required.

🔧 Assembly Instructions

1. Remove Stock Screws: Unthread the 4x stock screws from the bottom/corners of your Home Assistant Green casing. Note: Keep these safe in case you ever want to revert the device back to its original desktop configuration.

2. Align Spacers: Place the 4x printed spacers (HomeAssistantGreenSpacer_4x.3mf) over the screw holes on the mounting tray of the printed bracket.

3. Mount the Device:

   • Slide the Home Assistant Green onto the mounting tray so that its translucent front face aligns with the front faceplate's rectangular viewing window.

   • From the honeycomb-grille side of the shelf, insert your 4x M3 x 25mm SHCS through the bracket holes, through the printed spacers, and thread them directly into the mounting holes of the Home Assistant Green.

   • Tighten firmly, but be careful not to over-tighten and strip the plastic threads.

4. Install Keystone & Cable:

   • Snap your RJ45 Keystone coupler into the designated front-facing slot on the bracket.

   • Connect the short patch cable from the Ethernet port on the back of the Home Assistant Green to the rear socket of the Keystone coupler.