Metalfish S5 Max - Front Intake 92mm Fan Duct
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Hide your cables and give your CPU some fresh air!
- Ocena
- 0 / 5
- Polubienia
- 1
- Pobrania
- 1
- Wydruki
- 0
- Wyświetlenia
- 56
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Computers
- Licencja
- Creative Commons — Attribution — Noncommercial
An intake fan duct for a 9215 fan! 15 means that the fan should be 15mm in width, if your GPU is longer than ~252mm. If your GPU is shorter than ~252mm - then a 25mm fan can be installed.
It also conveniently hides your cables. Be aware that I am using an ATX PSU with non-modular cables. You can see where the cables come out of the PSU and they are not in the way of the intake duct. It might work with modular PSUs, but YMMV.
Install with M3 screws right through the vent holes, like in the picture (of course you can use stainless steel countersink screws which will be a lot less visible).
My GPU is a black Palit RTX 5060 8GB Dual OC, which is 262mm long + a 3d printed white cover from Palit's official website. The duct is very close to the GPU but it's still not touching it.
I had a 10 degrees decrease in temperature for the CPU. I highly advise that you install a 120mm fan... next to my 2x HDD/SSD holder seen below to achieve the minimum temperatures in this air-thirsty case:
Check out my collection for the Metalfish S5 Max accessories!
https://www.printables.com/@NikitaIgn/collections/3524100