Nitecore P23i GoPro-Style Mount Adapter

Nitecore P23i GoPro-Style Mount Adapter

A 3D-printable adapter for mounting the Nitecore P23i flashlight to standard GoPro-style mounts.

Compatibility

Designed and tested for the Nitecore P23i.

Official reference specifications:

• Length: 143.5 mm

• Head diameter: 31.8 mm

• Weight without battery: 114.5 g

Not verified for other Nitecore P-series flashlights.

Recommended print settings

• Material: PETG or ASA

• Nozzle: 0.4 mm

• Layer height: 0.20 mm

• Walls: 5–6

• Top and bottom layers: 5+

• Infill: 40–60%

• Supports: required beneath the GoPro mounting section

• Brim: recommended for ASA

ASA is recommended for prolonged outdoor, vehicle or marine use. PLA is suitable only for test fitting or light indoor use.

Use the tested upright orientation shown in the listing images. Good layer adhesion is important around the GoPro mounting fingers.

Hardware

• 1 × standard GoPro-style M5 thumb screw

• 1 × compatible M5 nut, where required

• Optional safety tether

Installation

1. Inspect the print for cracks or poor layer adhesion.

2. Insert the P23i into the holder.

3. Attach the adapter to a compatible GoPro-style mount.

4. Tighten the thumb screw without crushing the printed fingers.

5. Shake-test the assembly before use.

Do not force the flashlight into the holder if the print begins to crack.

Safety

This is a non-certified 3D-printed accessory. Strength depends on the material, print orientation, layer adhesion, hardware and operating temperature.

Use a separate safety tether where failure could cause injury, damage or loss. Do not use this model as certified PPE or life-safety equipment.

Files

• STL printable model

• STEP CAD source

• Optional tested OrcaSlicer 3MF

Changelog

v1.0

Initial release.

Please post a make with your material, orientation and fit feedback.