1 / 5
Adapter plate for side mounting the display of the creality Ender 5 — zdjęcie 1
1 / 5

Adapter plate for side mounting the display of the creality Ender 5

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

This plate allows the display of the Ender 5 to be mounted sideways without colliding with the print bed.

Ocena
0 / 5
Polubienia
8
Pobrania
31
Wydruki
0
Wyświetlenia
408
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Licencja
Creative Commons — Attribution

Print settings:

  • Layer height: at least 0.2mm
  • Infill: 20%
  • Perimeter: 3 and more
  • Support structures are not required

Tools needed:

  • Drill bit (for finishing if the printer did not get the holes right).
  • Hexagon spanner (included with the printer)
  • Screwdriver (must match your own screws)

Additional parts needed:

  • 2x m3 screws (at least 10mm long)
  • 2x m3 hexagon nut

Installation:

  1. Attach the adapter plate to the frame using the holes marked in yellow (just like when setting up with the other components). The small opening must face the frame. The screws and nuts that previously held the display should be used for this.
  2. Insert the hexagon nuts into the corresponding green recesses (if this is not possible, pull in a screw from the other side).
  3. Hold the display on the corresponding side and screw it in through the holes marked in blue.
  4. Insert the end caps into the yellow holes.

 

 

Druckeinstellungen:

  • Schichthöhe: mindesten 0.2mm
  • Infill: 20%
  • Perimeter: 3 und mehr
  • Stützstrukturen werden nicht benötigt

Benötigtes Werkzeug:

  • Bohrer (zum nachbearbeiten, wenn der Drucker die Löcher nicht gut genug hinbekommen hat)
  • Sechskantschlüssel (Im lieferumfang des Druckers enthalten)
  • Schraubendreher (muss zu den eigenen Schrauben passen)

Zusätzlich benötigte Teile:

  • 2x m3 Schrauben (mindestens 10mm lang)
  • 2x m3 Sechskantmutter

Einbau:

  1. Adapterplatte mit den Gelbmarkierten Löchern am Rahmen befestigen (genau wie beim Aufbau mit den anderen Komponenten). Die kleine Öffnung muss zum Rahmen zeigen. Dazu sollen die Schrauben und Muttern verwendet werden, die das Display vorher gehalten haben.
  2. Die Sechkantmuttern in die entsprechenden grünen Aussparungen einlegen (wenn es nicht geht mit einer Schraube von der anderen Seite reinziehen)
  3. Display an die Entsprechende Seite halten und durch die Blau markierten Löcher Festschrauben.
  4. Die endkappen in die gelben Löcher einsetzen.

Tagi