Radiomaster TX16S MK3 - Right/Left slider lever redesign
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Redesign (longer and angled) of the levers of the right and left sliders (RS & LS) of the Radiomaster TX16S MK3 radio
- Ocena
- 0 / 5
- Polubienia
- 4
- Pobrania
- 35
- Wydruki
- 1
- Wyświetlenia
- 239
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- RC & Robotics
- Licencja
- Creative Commons — Attribution — Noncommercial — NoDerivatives
Although the RM TX16S Mk3 is a decent enough radio, the right and left slider levers are horrible. I use these as throttle for a F5J glider (and other gliders) and in case of quick response (during approach or low altitude) my finger can't find the levers or they slide of. Particularly the fillet at the end is not nice.
I modelled an angled lever (that I use now) and a strait lever. Choose which suits you best.
I printed these from PETG with a 0.4mm nozzle and 0.2mm layerheight. When removing the "switch corners" of the radio, all you need to to is remove the two black philipshead screws, remove the printwith the pot and remove the plastic piece from the pot.
The replacement part is a drop in (at least it is for me with my print settings).
In case you have trouble replacing the little printboard, remove or loosen the aluminium nuts on top of the 2 switches to give some room.
Reassemble and of you go!
Digital Solidmodel (STEP) files are available upon request for a small (€1,- or €2,-) Paypall donation (DM me if required)