1 / 6
Wall-Mount for tool holder of Rowenta X-Force Vacuum — zdjęcie 1
1 / 6

Wall-Mount for tool holder of Rowenta X-Force Vacuum

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

Wall mount with same profile as charging station, so you can mount the original tool holder separately

Ocena
0 / 5
Polubienia
0
Pobrania
7
Wydruki
0
Wyświetlenia
56
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Licencja
Creative Commons — Attribution — Share Alike

Don't want your accessories right below the charging station? Want to mount them somewhere else?

But the (very good) original tool holder clips into the charging dock and can't be mounted to the wall by itself?

No problem, clip the tool holder into this custom wall mount.

Features

  • 30mm distance from wall

    • enough space to hang a Aqua Head or other accessory head.

  • 3 screw holes for up to M6 screws for strong hold (you don't need to use them all)

  • tested with Rowenta X-Force Flex 14.80 Vacuum

Printing

  • Material: PETG or PCTG or PC or GreenTecPro

  • part orientation: auto (imagined screws in holes would point down)

  • Support: none needed

  • Brim: no

  • Nozzle size: larger ist better

  • Layer Height: Standard for your nozzle size. e.g. 0.40mm with 0.8mm nozzle

  • Infill: 13% Honeycomb

  • Wall-Strength: 3 on 0.8mm. 4 on 0.6mm nozzle. 5 on 0.4mm nozzle.

Warning & Feedback appreciated

Tested with Rowenta X-Force Flex 14.80 Vacuum. Other models may vary (but probably don't)

Uploaded part is slightly refined version of tested part, but has itself not been tested.

Differences:
  • Hole to access and release latch, so holder can be removed from wall

  • Width of rails has been increases for easier fit.

License

Creative Commons Attribution-ShareAlike 4.0 International — CC BY-SA 4.0

  • Share with others

  • Don't keep your modifications to yourself

  • Always attribute the source!

Tagi