Elegoo CC1 & CC2 Magnetic Filament Waste Bin
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
A purge bin for elegoo CC1 and CC2 machines
- Ocena
- 0 / 5
- Polubienia
- 5
- Pobrania
- 37
- Wydruki
- 0
- Wyświetlenia
- 329
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Accessories
- Licencja
- Creative Commons — Attribution
A filament purge bin for Elegoo Centauri Carbon 1 & Centauri Carbon 2 machines. It may fit other machines where the chute width is about 42mm wide or less.
The first model is 78mm in height (71mm internally usable for filament waste) (small version)
The second model is 108mm in height (98mm internally usable for filament waste) (larger version)
Settings
Filament Used: PLA
Layer Height : .2
Supports: Yes
Magnets
The Magnet indentations are press fit. To install the magnets, align the magnet over the cavity against a hard surface. Press down on the indentation inside the bin over the magnet. You should hear a slight click sound when it snaps in place. You can apply adhesive if you like but once the magnets are pressed in, they are hard to get out even without adhesive. There is a pressure release hole in the back of the magnet indentation that can be used to remove the magnet. Although, it is likely that the tiny nodules that are within the magnet cavity cutout would be damaged since the magnet cavity is designed with a very tight clearance.
The bin needs four 8x3mm magnets which when measured were about 8 x 2.54 in reality (at least the ones I purchased). If you purchase 8X3mm and they do not press fit into the holes, please let me know.
The debossed version lettering will only show when viewing the stl in wire or xray view in the stl viewer. Opening the stl file in a slicer and going into paint the object, the lettering becomes selectable when using the Fill tool type. The debossed lettering sits essentially flush with the top layer.