Photo Box with Sliding Lid - 10x15 cm / 4x6 inch
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
A simple stackable box to keep your 10x15 cm (4x6") photo prints tidy.
- Ocena
- 0 / 5
- Polubienia
- 5
- Pobrania
- 17
- Wydruki
- 0
- Wyświetlenia
- 75
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Home Decor
- Licencja
- Creative Commons — Attribution
A simple stackable box to keep your 10x15 cm (4x6 inch) photo prints tidy. The lid slides over the base like a shoebox and holds by friction - no clips, no hinges, nothing to break. Two finger cut-outs on the short sides let you lift the pictures out easily.
It comes in three weights, so you can trade material against looks and sturdiness:
Solid (
fotobox_bottom/fotobox_top) - closed walls, ~68 cm³ per part. Strongest, cleanest look.Light (
fotobox_hex_*) - honeycomb floor and walls, solid lid skirt. ~43 / 49 cm³.Ultra-light (
fotobox_more_hex_*) - honeycomb everywhere, including the lid skirt. ~37 cm³ per part, roughly 45 % less material than the solid version.
Dimensions
Inside usable space: 110 × 160 × 28 mm
Outside (closed): 118.8 × 168.8 × 32 mm
Wall / floor thickness: 2 mm
Printing
No supports needed on any version.
Base prints bottom-down; lid prints upside-down (open side up, roof on the plate).
PLA or PETG both work. Suggested: 0.2–0.3 mm layers, 2–3 perimeters; on the solid version 10–15 % infill on the floor is plenty.
Needs ~170 mm on one axis - fits most printers. Designed and printed on an Anycubic Predator (delta).
Lid fit
Designed with 0.4 mm clearance per side for a smooth friction fit. If it's too tight, scale the lid up ~0.3 %; if too loose (more likely on the ultra-light lid, since the perforated skirt grips less), use the solid or light lid instead - they hold better.