1 / 3
🌹‖ WIRED Spiral Vase Rose Stem (REINFORCED)
Zamów wydruk tego modelu
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Organic-like stem for 7cm rose, contains hole for 2mm diameter wire.
- Ocena
- 0 / 5
- Polubienia
- 14
- Pobrania
- 63
- Wydruki
- 0
- Wyświetlenia
- 760
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Other Art & Designs
- Licencja
- Creative Commons — Attribution — Noncommercial
SzczegółyPliki (3)Wydruki i komentarze (Wydruki: 0) (Komentarze: 0)Remiksy (0)Kolekcje (10)Powiązane
Info:
- variation of original organic stem for 7cm rose 🌹 in vase mode
- since original stem broke for me very quickly 😅 I tried reinforcement
- stem is hollow
- at the end of print, insert 14cm long (max) and 2mm thick metal wire
Print info:
- there is marked print pause near the end
- so while stem is still on the plate, insert wire
- if it's too loose, glue it
- you can either end the print (and have bottom unclosed)
- or continue and printer will close the hole
- but beware! if the wire is strong and it's not perfectly straight, it can deform the stem on the plate, so your printer may print on different area after the pause, as a quick solution, you can hold the stem by hand during the print after the pause (it's about few seconds only) and somehow navigate printer where to print the rest :)
- hint: try to make the wire as straight as possible before inserting it (the hole is straight too)