1 / 3
🌹‖ WIRED Spiral Vase Rose Stem (REINFORCED)
Order a print of this model
We calculate the final price from your selected file. You review and accept it before payment.
Estimated printing price per file
€1.27 – €1.55 net (excluding VAT)
For file: Stem_7cm_organic_hollow_0.2mm_PLA_MK3S_1h41m.gcode
This is an estimate for one file. You’ll confirm the exact price before ordering.
File and estimate settings
File used for this estimate
Average indicative estimate: €1.41 excluding VAT (range midpoint).
- Weight reported by the author
- 12 g
- Print time reported by the author
- 1.68 hr
- Source material
- PLA
- Estimate material
- PLA
- Estimate printer
- Bambu Lab P1S - 0.4 nozzle
- Estimate process
- 0.20mm Standard
Indicative estimate for the selected file only, based on the author’s weight and print time. File variants are not added together. The final price is calculated after file analysis.
Saved on this device.
Organic-like stem for 7cm rose, contains hole for 2mm diameter wire.
- Rating
- 0 / 5
- Likes
- 14
- Downloads
- 63
- Makes
- 0
- Views
- 761
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Other Art & Designs
- License
- Creative Commons — Attribution — Noncommercial
Info:
- variation of original organic stem for 7cm rose 🌹 in vase mode
- since original stem broke for me very quickly 😅 I tried reinforcement
- stem is hollow
- at the end of print, insert 14cm long (max) and 2mm thick metal wire
Print info:
- there is marked print pause near the end
- so while stem is still on the plate, insert wire
- if it's too loose, glue it
- you can either end the print (and have bottom unclosed)
- or continue and printer will close the hole
- but beware! if the wire is strong and it's not perfectly straight, it can deform the stem on the plate, so your printer may print on different area after the pause, as a quick solution, you can hold the stem by hand during the print after the pause (it's about few seconds only) and somehow navigate printer where to print the rest :)
- hint: try to make the wire as straight as possible before inserting it (the hole is straight too)