1 / 4
Voron Trident R2 AB motors pin mod and short shaft double shear (monolith + Crazy Ivan) — zdjęcie 1
1 / 4

Voron Trident R2 AB motors pin mod and short shaft double shear (monolith + Crazy Ivan)

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

Modified version of the Trident R2 motor mounts to work with the monolith short shaft double shear housing.

Ocena
5 / 5
Polubienia
17
Pobrania
56
Wydruki
1
Wyświetlenia
623
Oceny
2

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Licencja
GNU General Public License v3.0

Intro:

Thanks to the Voron team for providing the f360 timeline files which helped tremendously!

This mod reduces the thickness of the plates to 5mm (same as R1) to enable the motors to be closer to the belt path to enable higher tensions. For best results, mount the motors "Crazy Ivan" style, where the A motor sits above the bearing mount and the B motor stays below (see below).

The below setup also shows compatibility with the monolith gantry short shaft double shear housings.

I am currently running without double shear with 6mm EPDM belts, reaching a tension reading of 2.5 on the PF Makes tension meter.

BOM:

The usual R2 parts apply (M5x10 and F695 bearing stacks). Additionally since this is a pin mod you will need:

  • 4x M5x30mm pins (sand them down using a drill bit and sandpaper if your bearings are too tight)

  • 1 each of the printed parts in this mod (4 in total)

  • 8x M3x35mm socket head screws + M3 1mm washers to mount the motors

Assembly instructions:

Follow the Trident manual but mount the motors as per the picture using the slightly longer M3 screws in the BOM.

The pulley position on the motors should be identical, following the config for the B motor (the one mounted below). Use the R1 printed spacer guide to help determine the height as this mod follows the same thickness.

Optional: Short shaft double shear

You will need an additional:

Tagi