Creality K1Max 2-Piece Cartographer v4 Mount
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
A 2-piece K1-Max Cartographer v4 (standard) mount designed for Lidar port connection and easier removal/install.
- Ocena
- 0 / 5
- Polubienia
- 4
- Pobrania
- 31
- Wydruki
- 0
- Wyświetlenia
- 261
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Creality Parts & Upgrades
- Licencja
- Creative Commons — Attribution — Share Alike
Two-Piece Cartographer v4 (Standard) Mount for K1 Max
This mount is designed to be used with the Cartographer 3D v4 (Standard) probe. This is a side mounted design, featuring zero Y offset, reducing the effects of Axis Twist.
Although this mount was created from scratch the bottom half that holds the Cartographer is based on AfroPsycho's design (hence this model is marked as a remix).
The top half is an original design with a two part attachment using an L-shaped bracket that is intended to be permanently attached to the tool-head and a Cartographer mount that attaches to the L-bracket using M2.5 machine screws into heat set inserts.
The rationale for the two part mount is because most of these mounts suggest using machine screws into the plastic which is fragile and prone to stripping (mine stripped after removing/replacing just a couple of times even though I was very careful). This design's approach uses the original correct self-tapping screws intended for plastic. The L-bracket can be installed once and then the cartographer removed separately using the machine screws into the heat set inserts.
This design is intended to be used with cartographer connected to the lidar port. If using USB cable to front port I recommend using AfroPsycho's design as it includes cable routing guide.
This design should fit other k1-series printers however since other models don't support connecting the Cartographer to the lidar port it's not recommended.
BOM
3D printed bracket and mount
2x self tapping screws from the original lidar mount (L-bracket to tool head)
2x M2.5 heat set inserts (max depth 4mm) (in L-bracket) (eg: these)
2x M2.5 6mm hex head machine screws (Cartographer mount to L-bracket) (eg: these)
2x M2.3 4mm self-tapping screws (Cartographer to mount) (eg: these)
Print Settings
0.2mm layer height
Print in high-temp filament (ASA recommended)
Print L-bracket flat, no supports
Print mount in final orientation, with supports
See slicer screen shot for recommended orientation and supports
Installation
Installation is straight forward:
Insert the heat-set inserts into the L-bracket
Attach the L-bracket to the tool head using the original lidar mount self-tapping screws.
Attach the cartographer to the mount using 2x M2.3 4mm self-tapping screws.
Attach cable to the cartographer.
Attach the cartographer mount to the L-bracket using M2.5 6mm machine screws.
Connect cable to the lidar port.
Configuration
Exactly the same as AfroPsycho's mount.