1 / 9
DIY Ultimate Tiny Whoop Ground Station - Radio controller with built in analog monitor — zdjęcie 1
1 / 9

DIY Ultimate Tiny Whoop Ground Station - Radio controller with built in analog monitor

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

Easy and cheap DIY project to 3D print your own ELRS Radio with a built in screen.

Ocena
0 / 5
Polubienia
1
Pobrania
2
Wydruki
0
Wyświetlenia
52
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Kategoria
RC & Robotics
Licencja
Creative Commons — Attribution — Noncommercial — Share Alike

Ground station for Tiny Whoops! 

I've designed this controller from the ground up to combine a Skyzone M5 analog monitor with a BETAFPV LiteRadio 2 SE ELRS radio controller.

It can be used with any ELRS drone that has an analog VTX, but I'll mainly be using it with small whoops.

Features

  • Powered by a single 18650 Battery

  • ELRS with built in antenna

  • Analog Video system - dual antenna

  • Access to Skyzone M5 control panel

  • Charged with a USB-C

  • 2x 3 position switches

  • Original controller power button

  • Controller batterylevel indicated on an OLED display (Optional) 

The Literadio comes with two 2-position switches and two 3-position switches. Since two 3-position switches provide all the functionality I need, I designed the controller to use only those two switches.

Hardware

  • BetaFPV LiteRadio 2 SE

  • Skyzone M5 VRX Monitor

  • 18650 battery and holder

  • USB-C Male & Female

  • M2 & M3 Screw set

  • Momentary switch (LiteRadio on/off)

  • OLED display & tiny on/off switch 

Most of the hardware has been purchased through Aliexpress.

Support my work: All of my models are available for free. If you'd like to show your appreciation, consider Buying Me A Coffee.

Filament: PLA 

History

Some years ago I designed a controller for HD FPV and ELRS controller using the Jumper T-Pro, a HD monitor and Walksnail VRX. This turned out to be too complicated, I lost the motivation and ended up scrapping the project. 

Later I was inspired by Hoarder Sam on Youtube to use the Betafpv LiteRadio 2 SE as a base controller. This is a very simple controller compared to the Jumper T-Pro, and combined with a analog monitor with the VRX built-in and everything running on a single 18650, this turned out to be easy enough for me to complete the project.

Instructions

The model consist of 5 pieces. A main body, circuit board holder, rear plate, rear cover and OLED & switch mounting plate. 

More info will be provided later. - Parts of this video can be used as instructions as the same Betafpv Literadio is used in that project. 

Tagi