DIY Ultimate Tiny Whoop Ground Station - Radio controller with built in analog monitor
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Easy and cheap DIY project to 3D print your own ELRS Radio with a built in screen.
- Rating
- 0 / 5
- Likes
- 1
- Downloads
- 2
- Makes
- 0
- Views
- 54
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- RC & Robotics
- License
- Creative Commons — Attribution — Noncommercial — Share Alike
Ground station for Tiny Whoops!
I've designed this controller from the ground up to combine a Skyzone M5 analog monitor with a BETAFPV LiteRadio 2 SE ELRS radio controller.
It can be used with any ELRS drone that has an analog VTX, but I'll mainly be using it with small whoops.
Features
Powered by a single 18650 Battery
ELRS with built in antenna
Analog Video system - dual antenna
Access to Skyzone M5 control panel
Charged with a USB-C
2x 3 position switches
Original controller power button
Controller batterylevel indicated on an OLED display (Optional)

The Literadio comes with two 2-position switches and two 3-position switches. Since two 3-position switches provide all the functionality I need, I designed the controller to use only those two switches.
Hardware
BetaFPV LiteRadio 2 SE
Skyzone M5 VRX Monitor
18650 battery and holder
USB-C Male & Female
M2 & M3 Screw set
Momentary switch (LiteRadio on/off)
OLED display & tiny on/off switch
Most of the hardware has been purchased through Aliexpress.

Support my work: All of my models are available for free. If you'd like to show your appreciation, consider Buying Me A Coffee.
Filament: PLA
History
Some years ago I designed a controller for HD FPV and ELRS controller using the Jumper T-Pro, a HD monitor and Walksnail VRX. This turned out to be too complicated, I lost the motivation and ended up scrapping the project.

Later I was inspired by Hoarder Sam on Youtube to use the Betafpv LiteRadio 2 SE as a base controller. This is a very simple controller compared to the Jumper T-Pro, and combined with a analog monitor with the VRX built-in and everything running on a single 18650, this turned out to be easy enough for me to complete the project.

Instructions
The model consist of 5 pieces. A main body, circuit board holder, rear plate, rear cover and OLED & switch mounting plate.
More info will be provided later. - Parts of this video can be used as instructions as the same Betafpv Literadio is used in that project.


