Cases for Adafruit QT Py and SHT45 sensor board
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Tiny cases for QT Py and SHT boards w/ magnetic mount. E.g. to equip your 3D printer chamber w/ a precise temp sensor.
- Ocena
- 0 / 5
- Polubienia
- 5
- Pobrania
- 30
- Wydruki
- 0
- Wyświetlenia
- 187
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Electronics
- Licencja
- Creative Commons — Attribution — Share Alike
These are cases for an Adafruit QT Py board and a temperature sensor board like the Adafruit SHT45.
I designed them to be as small as possible, so that I can put them into my P1S 3D printer to get an accurate chamber temperature. But of course, you can use it anywhere ... maybe except outdoors :D
At the bottom are holes for 6x2mm magnets. The lids are clipped into the main part.
Since I use mine inside the 3D printer chamber, I printed them im ASA. If you use a similar filament, make sure to dial in the shrinkage factor correctly.
Print settings:
2 walls, inner/outer/inner
0.2mm layer height
15% Gyroid infill
supports for the magnet holes